LIST OF PUBLICATIONS:   Refereed Published Journal Papers, Conference Proceeding Papers and Papers Submitted for Conference and Publication:     Kazi, M.S.N. (1981). New look at maintenance of a process plant. Proceedings, 26th annual convention of the Institution of Engineers, Khulna, Bangladesh. Kazi, M.S.M. (1982). Behaviors of an induced draught fan. Proceedings, 27th annual convention of the Institution of Engineers, Dhaka, Bangladesh. Kazi, M.S.N. (1984). K2CO3 deposition is the cause of abnormal vibration of a CO2 centrifugal compressor in a process plant. Proceedings, 28th annual convention of the Institution of Engineers, Dhaka, Bangladesh. Kazi, M.S.N. (1985). Changing of duplex angular contact ball bearings by a pair of deep groove ball bearings at the driven end of a low-pressure solution pump. Proceedings, 29th annual convention of the Institution of Engineers, Chittagong, Bangladesh. Kazi, M.S.N. (1985). Study of the effect of run out on vibration characteristics of an alternator shaft. Proceedings, 29th annual convention of the Institution of Engineers, Chittagong, Bangladesh. Kazi, M.S.N. (1985). Oil contamination of a non-condensing turbine. Proceedings, 10th annual Bangladesh Science conference, Dhaka, Bangladesh. Kazi, M.S.N. (1985). Steam, gas and air trap in process industries. Proceedings, 10th annual Bangladesh Science conference. Kazi, M.S.N. (1985). Effect of excessive vibration on bearing temperature of a centrifugal gas compressor. Proceedings, 10th annual Bangladesh Science conference, Dhaka, Bangladesh. Kazi, M.S.N. (1985). Vibration problem study of anti friction bearings. Proceedings, 10th annual Bangladesh Science conference, Dhaka, Bangladesh. Kazi, M.S.N. (1987). Study of rubbing vibration characteristic of an overhung rotor. Proceedings, 12th annual Bangladesh Science conference, Jahangir Nagar, Dhaka, Bangladesh. Kazi, M.S.N. (1990). Study of forced convection heat transfer over smooth and finned tubes. Proceedings, 34th annual convention of the Institution of Engineers, Dhaka, Bangladesh. Kazi, M.S.N. (1991). Study of forced convection heat transfer over three heated angular finned tubes. Proceedings, 35th annual convention of the Institution of Engineers, Chittagong, Bangladesh. Kazi, M.S.N. (1992). Appearance of target plate when the steam blowing is over. Proceedings, 17th annual Bangladesh Science conference, Gazipur, Dhaka, Bangladesh. Khan, M.H. and Kazi, M.S.N. (1992). Effect of fin angles on cross flow heat transfer from a tube. Journal of the Institution of Engineers, India, Mech. Engg. Division, Vol. 73, No. 1, pp.145-148. Kazi, M.S.N. (1993). Steam blowing and acceptance criteria. Journal of Institution of Engineers Bangladesh, vol.21,no. 1. Kazi, M.S.N. and Khan, M.H. (1993). An Experimental study of forced convection heat transfer over finned tubes. Proceedings, 37th annual convention of the Institution of Engineers, Bangladesh, Rajshahi, Bangladesh. Kazi, M.S.N. (1993). Corrosion effect on tubes of a carbamate condenser in a urea plant. Proceedings, 37th annual convention of the Institution of Engineers, Bangladesh, Rajshahi, Bangladesh. Kazi, M.S.N. (1994). An experimental study of forced convection heat transfer over finned tubes of different fin configuration. Proceedings, 38th annual convention of the Institution of Engineers, Bangladesh, Dhaka, Bangladesh. Kazi, M.S.N. and Khan, M.H. (1995). An experimental study of forced convection heat transfer over a finned tube for different orientations. Proceedings, 6th Asian congress of fluid mechanics, Vol. 2, Singapore. Kazi, M.S.N. and Khan, M.H. (1999). Effect of fin pitches on cross flow heat transfer from a tube. Submitted for publication in the Journal of the Institution of Engineers, India. Kazi, M.S.N., Duffy, G.G. and Chen, X.D. (1998). Heat Transfer to Natural Fibre suspensions. Proceedings of IPENZ Conference, Auckland, New Zealand, 1998, Vol. 5, pp. 91-96. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (1998). Heat Exchanger Fouling Mitigation with Flexible Fibres. Proceedings of 26th CHEMECA Conference, Port Douglas, Queensland, Australia, 1998, Paper no.177.6. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (1999). Heat Transfer in the Drag Reducing Regime of Wood Pulp Fibre Suspension Flow. Chem. Eng. Journal, 1999, CE2655, Vol. 73, pp. 247-253. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (1999). Heat Transfer Coefficient-a New Method to Relate Fibre and Paper Properties. Proceedings of 27th CHEMECA Conference, New Castle, Australia, 1999, Section 6, p. 162 and CD Rom. Kazi, M.S.N., Chen, X.D., Duffy, G.G. and Muller-Steinhagen, H.M. (1999). Fibre Modified Scaling Mechanisms in Heat Transfer Fouling Mitigation. Proceedings of Mitigation of Heat Exchanger Fouling and its Economic and Environmental Implications, Banff, Canada, 1999, Section V, pp. 1-8. Duffy, G.G., Kazi, M.S.N. and Chen, X.D. (2000). Heat Transfer Coefficient-a New Way to Monitor Wood Pulp Quality. Proceedings of 54th Annual Appita Conference, Melbourne, Australia, 2000, Paper 4B12, Vol. 2, pp. 605-614. Duffy, G.G., Kazi, M.S.N. and Chen, X.D. (2000). Heat Transfer to Fibre Suspensions in Annular Flow. Proceedings of 28th CHEMECA Conference, Perth, Australia, 2000, Paper no. C-4.2, pp. 366-369. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (2002). Fibre Modified Scaling in Heat Transfer Fouling Mitigation. Chem. Eng. Comm., 2002, Vol. 189, No. 3, pp. 1-17. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (2001). Heat Transfer Fouling Mitigation with Wood Pulp Fibres. Proceedings of Heat Exchanger Fouling, Fundamental Approaches and Technical Solutions, Davos, Switzerland, 2001, Section iii, pp. 21-27. Kazi, M.S.N., Duffy, G.G. and Chen, X. D. (2001). A Study of Fouling and Fouling Mitigation on Smooth and Roughened Metal Surfaces and a Polymeric Material. Proceedings of Heat Exchanger Fouling, Fundamental Approaches and Technical Solutions, Davos, Switzerland, 2001, Section iii, pp. 9-17. Duffy, G.G., Kazi, M.S.N. and Chen, X.D. (2002). Pressure Drop Measurement-a New Way to Monitor Wood Pulp Quality. Proceedings of the 56th Annual Appita Conference, Rotorua, New Zealand, March, 2002. Duffy, G.G., Chen, X.D. and Kazi, M.S.N. (2002). Fibre Particle Characterisation. Proceedings of the Hydrotransport 15 Conference, Banff, Canada, June, 2002. Kazi, M.S.N., Chen, X.D. and Duffy, G.G. (2002). Cleaning of Mineral Fouling Deposits on Heat Exchanger Surfaces. Proceedings of the 30th Chemeca Conference, Christchurch, New Zealand, September, 2002. Kazi, M. S. N., Duffy, G.G. and Chen, X.D. (2002). A Study of Heat Transfer and Pressure Loss of Suspensions of Synthetic Filaments and Wood Pulp Fibres in Annular Flow. Proceedings of the 30th Chemeca Conference, Christchurch, New Zealand, September, 2002. Kazi, M.S.N., Duffy, G.G. and Chen, X.D. (2002). Validation of Heat Transfer Data for Fibre Suspensions in Annular Flow. Proceedings of the 30th Chemeca Conference, Christchurch, New Zealand, September, 2002. Kazi, M.S.N., Duffy, G.G. and Chen, X.D. (2009). Fouling and Fouling Mitigation on Different Heat Exchanging Surfaces. Proceedings of Heat Exchanger Fouling and Cleaning Conference, Pichl, Schladming 8973, Austria, June, 2009.

Prof. Dr. Loo has conducted fascinating research over the 12 years in The University of Malaya, particularly in Lifelong Machine Learning, Explainable Robotics, Explainable AI and recently in Trustworth & Sustainable AI. His numerous publications on the topic have been well-received and have made a substantial contribution to the Continual Machine Intelligence.  He has published more than 200 peer-reviewed journal and conference papers on neurorobotics and machine intelligence. In high-impact journals such as IEEE Transactions on Neural Networks and Learning Systems, Neural Networks, Journal of Neural Systems, IEEE Transactions on Cognitive and Developmental Systems, IEEE Transactions on Cybernetics, to name a few. Prof. Loo is also the recipient of JSPS fellowship award from Japan and the Georg Forster Fellowship award from Humboldt Foundation, Germany, Belt and Road Academic Fellowship Scheme, China. He has been the visiting professor of Osaka Metropolitan University, Japan, and King Mongkut's Institute of Technology Ladkrabang, Thailand and Adjunct Professor in The Harry Butler Institute, Murdoc University. He has applied the developed theory to medical diagnosis, prognosis, and brain-inspired Machine Intelligence, and the potential of his research findings has been successfully demonstrated in various domains, including digital healthcare and cognitive robotics. Chu Kiong has been recognized for his excellence in applied research that has commercial potential based on the 10 patents filed. He is one of the founders of UM spin-off company, UMCH Sdn. Bhd. specializing in AI-enabled connected healthcare solutions.   Moreover, he is honoured Malaysia’s Research Star Award 2019 - Research and Innovation Excellence Awards, from the Ministry of Education as one of the most influential researchers in Malaysia. He received the Top Research Scientist Malaysia (TRSM) award 2020 from the Academy of Science Malaysia. 

Umi Kalsum Zolkafli @ Zulkifly  holds the Bachelor of Quantity Surveying from Universiti Teknologi Mara. She attained her Master of Science in Construction Contract Management from Universiti Teknologi Malaysia in the year 2008.  She completed her Doctoral degree in Built Environment from Universiti Teknologi Mara in the year 2017 and is now persuading her research interest in construction contract management and professional practice in built environment areas.  She worked with the industry for 10 years prior joining Universiti Malaya, as a Quantity Surveyor and Management Representatives at ARR QS Consultancy. Ever since joining UM as a Lecturer in 10th October 2008, Umi Kalsum Zolkafli @ Zulkifly received the certificate of Excellent Service by UM in the year 2012.  She has produced 2 Master graduates and currently supervising 5 PhDs.  She currently holds 26 publications including books, ISI-ranked articles, Scopus-indexed articles, chapters in book, as well as, in refereed international and national journals. She also has presented papers in conferences locally and internationally.   In addition, she also won Gold, Silver and Bronze awards for her innovation through research and development in multiple national competitions. One of her innovations through community reserach project had also received Intellectual Properties Copyrights. In terms of research grant, Umi Kalsum Zolkafli  has received  in total of RM 2,462,813.66 as principal investigator and co-researcher. She is also a reviewer for multiple international journals and conference proceedings. She is also actively involved with Board of Quantity Surveyors of Malaysia (BQSM) and Royal Institution of Chartered Surveyors Malaysia (RISM) as organizing committee for several international conferences, seminars and workshop Umi Kalsum Zolkafli @ Zulkifly registered as Consultant Quantity Surveyors (CQS) under the Board of Surveyors Malaysia  and a Fellow of The Royal Institution of Surveyors Malaysia (FRISM). She has served as a main committee of Quantity Surveying Division, RISM for more than 5 years.  In addition, she has contributed her expertise in accreditation of Degree programme for public and private Universities under Board of Surveyors Malaysia. She also one of the assessor for the Diploma accreditation programe with Royal Instituitions of Surveyors Malaysia